Condition Monitoring Interface Range

The condition monitoring interface range from Hydac connects sensor with interpretation. It is an all-purpose electronic instrument for converting the HSI signal from Hydac sensors into a standardised PC signal.

Using the HYDAC "FluMoS" PC software, it is therefore possible to read the data and measured values of the connected sensors immediately. The long-term memory can also be read, as well as adjustments made and parameters set on the connected sensors (the setting options are sensor-dependent).

The fluid sensors Contamination Sensor CS 1000 and the Metallic Contamination Sensor MCS 1000 supply an HSI signal via the RS485 port, which is converted by the CSI-D-5 to USB. This ensures simple connection to the PC. The measured values can be read with the aid of the PC software FluMoS.

The HSI signal can be converted either into a RS 232 or a RS 485 signal. The RS 232 port and possibly an additional standard RS 232/USB adapter can be used to connect the CSI-B-2 to any PC.

By using the RS 485 port and an appropriate additional coupling module, connection to higher-level control and/ or bus systems is also possible.

• Input channels for HYDAC sensors
• Direct connection of the sensors via screw terminals
• Indication of the active interface via LED (RS232 / RS485)
• Very compact design
• Suitable for mounting on DIN rails
• Protection class IP40

Speak to our filtration technology division about your factory automation requirements.

CONTACT US